Normal Temperature Water Valve Low and High Leak Test/Testing Equipment
1. Product Description
Function test
A: Valve operation and Voltage minimum test
B: Power & Current consumption and flow rate test
C: Flow rate compare test between the outlets
D: Total Flow rate test compare
E: Low and High leak test
2. Technical Parameters
Test station |
One/ two /three (Separate curves for each station display and data preservation) |
Test cycle |
0-999s, can be set up |
The test voltage range of the test sample |
140V,220V,240V AC/50Hz, Voltage can be setup at the setup interface. |
Testing product type |
Dual-port inlet valve (Reserved for single-port inlet valve testing function, other fixture needs to another orders) |
Product test connector |
G3/4 |
Test air pressure |
0.3-1.2Mpa |
Water pressure measuring range |
0.200~10.00Bar,0.2Bar , accuracy is 0.01, 1~10Bar accuracy is 0.1Bar, the distance between the pressure sensor and the test sample's inlet. |
Water flow volume measuring range |
(1~10.00)Lit/min, electromagnetic type, accuracy is ±0.1%, resolution 0.01L. Due to the large flow rate span, so it needs to use two flow sensors. The water flow collection type is both output simultaneous acquisition, Reserved the measurement interfaces and hand valve at the connect port of the sensor, to facilitate the customer's to connect the flow meter to calibration. |
Medium temperature |
Normal temperature |
Water tank capacity |
Approximately 200L |
The water tank with the water level control and the automatic replenishment functions, it also has the insulation layer. |
The pipes at the tester are the circular system, through the water tank to recycling use the water source |